iglidur® J, thrust washer, mm
Low friction, low wear • Low wear against different shaft materials • Low coefficients of friction running dry • Vibration dampeningSelect article(s)
Iglidur® J | The fast and slow motion specialist
• Over 250 sizes available from stock • Low wear against different shaft materials
• Low coefficients of friction running dry
• Vibration dampening
• Good chemical resistance
• Best material to use with soft shaft materials
• Low moisture absorption
One main advantage of iglidur® J plain bearings is the combination of a low coefficient of friction when running dry and the low stickslip tendency. With a recommended maximum surface pressure of 35 MPa, iglidur® J plain bearings are not suitable for extreme loads.
| When to use it? • For high speeds • For highest wear resistance at low to medium pressures • Low wear against different shafts • Low coeffficient of friction in dry operation • Vibration dampening • Good chemical resistance • Best perfomance with soft shaft materials • Low moisture absorption | When not to use it? • When high pressures occur iglidur® G iglidur® W300 • When short term temperatures occur that are higher +120 °C iglidur® G iglidur® Z • When a low-cost bearing for occasional movements is necessary iglidur® G |
• Automation
• Printing industry
• Beverage technology
• Aerospace engineering
• Cleanroom etc.
Mechanical properties
One main advantage of iglidur® J plain bearings is the combination of a low coefficient of friction when running dry and the low stickslip tendency.
Certificates and standards
